Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - c0op3r

Pages: [1]
1
EverDrive N8 / Re: EverDrive-N8 PRO bug reports.
« on: January 07, 2020, 05:31 AM »
I have a Famicom (HVC-001) that has the NESRGB kit installed and the Voultar NESRGB-IGR switching circuit.

The system works fine with the original Everdrive N8, but with the Everdrive N8Pro it will not boot.  After spending a bunch of time with it, I was able to figure out that if I turn the power on while holding down the RESET key the cart will boot and work - BUT the system constantly palette swaps (which is normally done by holding Right one the D-Pad and press Start and Select at the same time).

If you turn the machine off and back on without holding RESET the cart will not boot.

I spoke to Voutar and got the following response:

"Sorry my man, I haven't the faintest idea with the Everdrive N8 Pro would cause that sort of behavior.
I know that the reset timings were dialed in to accommodate the original Power-Pak and the Everdrive N8, but I haven't any idea about the Everdrive N8 Pro.

-V"

Here you can see the system and the palette swap happening - the LED on the front of the Famicom is an RGB LED and each color indicates a palette.

http://www.c0op3r.com/images/Amiga/Famicom%20HVC-002.MP4

Pages: [1]