Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - highfro

Pages: [1]
1
EverDrive GB / Re: Is it possible to mod original x7 to rev.B?
« on: March 08, 2018, 04:40 PM »
I've found out you can get the REV A to work with any GBP by doing the 5V regulator mod following these instructions

https://imgur.com/FBYejzZ

and cutting pin 6 ( 5V VDD ) from daughter to mainboard

I'm able to get my rev A to boot every time and also am able to flash roms!

this is including a backlight and bivert mod

Where can I find pin 6?

the pins are marked on the back side of the PCB

https://imgur.com/P6vKWzV

I circled it in red here

I used a solder sucker to suck the solder out, then used my soldering iron on a really hot setting to heat up the pin to the point it pushed through the plastic that was holding it in(you might be able to get away with using flush cuts to cut away the pin between the boards). after i used a multimeter to check there was no continuity left between the daughter board and the main board.

2
You can try doing the 5V regulator mod following these instructions

https://imgur.com/FBYejzZ

and cutting pin 6 ( 5V VDD ) from daughter to mainboard

I'm able to get my rev A to boot every time on my GBP and also am able to flash roms!

this is including a backlight and bivert mod

3
EverDrive GB / Re: Is it possible to mod original x7 to rev.B?
« on: March 07, 2018, 10:28 PM »
I've found out you can get the REV A to work with any GBP by doing the 5V regulator mod following these instructions

https://imgur.com/FBYejzZ

and cutting pin 6 ( 5V VDD ) from daughter to mainboard

I'm able to get my rev A to boot every time and also am able to flash roms!

this is including a backlight and bivert mod

Pages: [1]