1
EverDrive GB / Re: Is it possible to mod original x7 to rev.B?
« on: March 08, 2018, 04:40 PM »I've found out you can get the REV A to work with any GBP by doing the 5V regulator mod following these instructions
https://imgur.com/FBYejzZ
and cutting pin 6 ( 5V VDD ) from daughter to mainboard
I'm able to get my rev A to boot every time and also am able to flash roms!
this is including a backlight and bivert mod
Where can I find pin 6?
the pins are marked on the back side of the PCB
https://imgur.com/P6vKWzV
I circled it in red here
I used a solder sucker to suck the solder out, then used my soldering iron on a really hot setting to heat up the pin to the point it pushed through the plastic that was holding it in(you might be able to get away with using flush cuts to cut away the pin between the boards). after i used a multimeter to check there was no continuity left between the daughter board and the main board.