Clarification: Save States on the FXPak Pro

[zombi]

Hello all,

I apologize for the noobish question, but I'm seeing conflicting information here and there.

Are Save States available on the FXPak Pro? If so, which firmware/update is needed?

Thanks.

[zaphro72]

They are not supported by an official firmware right now that I am aware of. I think there is an unofficial firmware with support for them but I am unsure.

[ErivandoXP]

SD2SNES firmware 1.10.3-frs-v11 (Unofficial) by FURiOUS

https://github.com/furious/sd2snes/releases/tag/v1.10.3

[zombi]

SD2SNES firmware 1.10.3-frs-v11 (Unofficial) by FURiOUS

https://github.com/furious/sd2snes/releases/tag/v1.10.3

Thank you!

[airangel]

Did this work for you? I downloaded the software and it says the sd2snes / m3nu.bin was not found. Is there anything else I need to download for it to work?

[Relikk]

Did this work for you? I downloaded the software and it says the sd2snes / m3nu.bin was not found. Is there anything else I need to download for it to work?

Is your SD card FAT32 formatted? Do you have a folder on the root of your card called "SD2SNES" with the firmware files inside it (m3nu.bin etc.)?

This is the latest release, also: https://github.com/furious/sd2snes/releases/tag/savestate_v12

[airangel]

I ended up getting the newest release, but unfortunately it won't work. It's based off the 1.10.3 firmware and my FxPak Pro doesnt run 1.10.3 properly, there are just flickering lines all over. So I have to use 1.10.1, so I won't be able to use this. Going to talk to Krikzz about a replacement because it doesn't work on the newest firmware.