Author Topic: SD2SNES not work. Black screen when I insert the SD card and boot my SFC.  (Read 2160 times)

0 Members and 1 Guest are viewing this topic.

Offline hsuchisen

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
    • View Profile
Hi all,
I bought a SD2SNES from  junfangames which is dealer from official linkage.
However, when I got SD2SNES, it always show black screen if I insert SD card.
If I did not insert SD card, it will show no SD card found.
Thus I tried sever SD card, included Toshiba, SanDisk...
But all the result is same.
I also use different firmware but symptom is same.
The led light of my SD2SNES is always turn on if I insert the SD card.

I have no idea now so call help here.
I would like to check if someone could give me any suggestion for this symptom.
Thanks a lot
« Last Edit: March 27, 2018, 03:16 PM by hsuchisen »

Offline FeverDrive

  • Hero Member
  • *****
  • Posts: 1299
  • Karma: +54/-0
  • Blast Processing advocate
    • View Profile
Try lifting the cartridge 1mm or more.
You don't have a shell so it's easier to insert the PCB all the way down.
WELCO
METOT
HENEX
TLEVEL

Offline hsuchisen

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
    • View Profile
Thank you, FeverDrive.
I will try it after I went home.
Actually, I have a shell and it was separated. Because I would like to see the LED light.
Thanks a lot

Offline hsuchisen

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
    • View Profile
Hi all,

I still got fail result. Not sure if it did not connect to system or not.
But I think it should be connected to my SFC because the screen will show "No SD card" message if I remove SD card on SD2SNES. 

Thanks a lot