« previous next »
Pages: [1]   Go Down

Author Topic: Joyzz PCB in Original shell ?  (Read 1148 times)

0 Members and 1 Guest are viewing this topic.

Offline TheShadowRunner

  • Full Member
  • ***
  • Posts: 129
  • Karma: +9/-0
    • View Profile
Joyzz PCB in Original shell ?
« on: January 17, 2020, 07:08 AM »
Hey all,
I was wondering if anyone tried to fit the joyzz PCB in an original 6button MD pad shell ?
Either in the original from way back then (SJ-6000) or in the JPN MD Mini controller ?
I would like maximum authenticity, if possible, using Sega's original rubbers, buttons etc..
Please lmk!
Logged

Offline KRIKzz

  • Administrator
  • Hero Member
  • *****
  • Posts: 3260
  • Karma: +489/-2
    • View Profile
Re: Joyzz PCB in Original shell ?
« Reply #1 on: January 17, 2020, 11:30 AM »
It will fit with modification of back cover
Logged

Offline TheShadowRunner

  • Full Member
  • ***
  • Posts: 129
  • Karma: +9/-0
    • View Profile
Re: Joyzz PCB in Original shell ?
« Reply #2 on: January 17, 2020, 03:42 PM »
Would you care for more precisions ?
A picture would be ideal if you've actually tried it ^^
Also do you still not plan to sell the Joyzz PCB alone / as DIY ?
Thanks for these infos.
Logged

Offline KRIKzz

  • Administrator
  • Hero Member
  • *****
  • Posts: 3260
  • Karma: +489/-2
    • View Profile
Re: Joyzz PCB in Original shell ?
« Reply #3 on: January 17, 2020, 08:07 PM »
At the moment i have plans to sell as DIY only 3 button version.


Logged

Offline TheShadowRunner

  • Full Member
  • ***
  • Posts: 129
  • Karma: +9/-0
    • View Profile
Re: Joyzz PCB in Original shell ?
« Reply #4 on: January 17, 2020, 08:28 PM »
Thank you very much for the clear picture, it'll help a lot.
And a Joyzz DIY PCB w/ 3 buttons sounds really interesting !
Of course 6 button DIY would be ideal but 3 is a great start, I'm eager to see this.
Logged
Pages: [1]   Go Up
« previous next »