Author Topic: Turbo EVERDrive 2.4 NOT working on PCE  (Read 3502 times)

0 Members and 1 Guest are viewing this topic.

Offline cristianmg13

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Turbo EVERDrive 2.4 NOT working on PCE
« on: September 08, 2018, 12:51 AM »
I recently purchased a Turbo Everdrive and it was version 2.4
Sometime is loads up and I can view the files and load up a game. But when the EVERDrive does load, the game will reset/crash itself after less than 1 minute. Pressing the reset button on the Everdrive does nothing. Manually turning off and on my PC Engine will sometimes load back the everdrive, but most times it wont. It is at this point that I will have to wait 30 minutes or so before putting in the Everdrive only for this scenario to happen all over again. I have tried this Everdrive with my original PC Engine and Core Grafx. I have made sure the switch was set to PCE and NOT Turbografx. I have tried different SD cards from different manufacturers and formatted them properly (then reinstalled the required files). I am not sure what could be causing my EverDrive to fail?
BOTH my PC Engine and Core Grafx load up regular HuCards instantly first time, everytime. So I can eliminate my PC Engines to not be faulty. ANYONE have any ideas?

Offline PsychoFox

  • Newbie
  • *
  • Posts: 16
  • Karma: +0/-0
    • View Profile
Re: Turbo EVERDrive 2.4 NOT working on PCE
« Reply #1 on: September 11, 2018, 07:52 PM »
If you've tested it on 2 consoles, they aren't modded, switch is on the right setting, and you're using a genuine power supply, then I'd reach out to Krikkz directly, since the same happening on two consoles does sound like a faulty ED. The behavior you explain does match what happens if I use the 2.x on one of my region modded consoles, which I understand has to do with not enough power being provided to the Everdrive due to the mod sucking some of it away.